Re: cannot get hardware acceleration on old notebook

Brian Paul <[email protected]>
Newsgroups gmane.comp.video.mesa3d.user
Organization VMware, Inc.
Message-ID <[email protected]>
I've never seen those instructions before but they're probably as good 
as any.  I haven't touched mach64 hardware in 10 years or so.

-Brian

On 10/05/2012 12:45 PM, [email protected] wrote:
> Brian, thank you for the reply.
>
> i'm trying to follow instructions from this guide:
>
> http://ubuntuforums.org/showpost.php?s=e456f2090f15d163f0f05b59349349b4&p=29080&postcount=1
>
> am i going in the right direction?
>
> by the way:
>
> $ lspci | grep VGA
> 01:00.0 VGA compatible controller: Advanced Micro Devices [AMD] nee
> ATI Rage Mobility P/M AGP 2x (rev 64)
>
>
> -----Original Message-----
> From: Brian Paul <[email protected]>
> To: junk_yard <[email protected]>
> Cc: mesa-users <[email protected]>
> Sent: Fri, Oct 5, 2012 8:09 pm
> Subject: Re: [Mesa-users] cannot get hardware acceleration on old notebook
>
> Your laptop is pretty old and googling I found that it has an ATI RAGE
> GPU (though the info above says MACH64RM).  I think you'd need the old
> Mesa mach64 or r128 driver.  Those drivers were removed from Mesa
> after the 7.11 release, about a year ago (and even then probably
> haven't been tested in years).
>
> So you'd have to build/install an old Mesa release (and maybe some old
> drm/kernel drivers too).  But since that's old code, it's hard to say
> what problems you might run into.
>
> -Brian
>
>
>
> _______________________________________________
> mesa-users mailing list
> [email protected]
> http://lists.freedesktop.org/mailman/listinfo/mesa-users
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.