Re: [Mjpeg-users] mjpegtools 2.0.0 RC1

Hallo

Teruel de Campo MD wrote:
> On Mon, 2011-01-24 at 17:39 +0100, Bernhard Praschinger wrote:
>> Hallo
>>
>> Teruel de Campo MD wrote:
>>> Bernie,
>>>
>>> Thxs for all of your work.
>>>
>>> I run opensuse 11.3
>>> gcc version 4.5.0 20100604 [gcc-4_5-branch revision 160292] (SUSE Linux)
>>>
>>> yuvdenoise / main.c
>>> line 813/184
>>>
>>> int cnt;
>>> int avg;
>>>
>>> were need it.
>>>
>>>
>>> All the best,
>> Can you please be a bit more descriptive ?
>> I use a opensuse 11.3 64 bit Version and I don't need it. Please post
>> the output of the configure script. I think there is something else wrong.
>
>
> The 2 lines 813/184 are commented out again and after that I run
> both ./configure and make. The outputs are atttached.
Thanks for the attached output of the config script. The only difference 
I see that you use compiler settings for a k8 CPU an I have a bareclona. 
:-/
I have the same problem as you here too. So I have put both variables 
back again. And put it into the CVS.


auf hoffentlich bald,

Berni the Chaos of Woodquarter

Email: [email protected]
www: http://www.lysator.liu.se/~gz/bernhard

------------------------------------------------------------------------------
The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE:
Pinpoint memory and threading errors before they happen.
Find and fix more than 250 security defects in the development cycle.
Locate bottlenecks in serial and parallel code that limit performance.
http://p.sf.net/sfu/intel-dev2devfeb