Re: lavplay does not work

On 12/18/2016 12:53 AM, Bernhard Praschinger wrote:
>> What was the setting when you did record the audio signal ? I would
>> guess that it was mono and 8Bit Samples and 44.1kHz samplerate. I
>> haven't seen such a setup long time ago. It can be that lavplay/glav
>>  have problems (=bug) playing such a audio stream back. Can you try
>> recording in Stereo, 16Bit and 44.1kHz ? And see if that makes any
>> difference ?
I just tested it with stereo setting, lavinfo shows what you would
expect, yet still no sound, just a loud pop when I start play back and
then deaf. I can email you the clip (only 8 Meg) or put it on my dropboz
- just to make sure it is not the clip. At any rate the clip plays well
in xine with sound. I also changed xine setting to use oss and it made
no difference, xine plays it well.
In a previous message you suggested to check mixer setting. aumix shows
that PCM is on, besides, both xmms or xine plays audio files perfectly
through my speakers connected to line output.
> I'm away from home till early March. Will do this test then and report
> on the result.
I did come back in March but have been busy with other stuff


------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot