Re: Lubuntu doesn't seem to recognize IOmega Buz capture card

Hallo,

William Lum wrote:
> Hi,
> 
> Thank you so much for continuing to try to help me.  I tried what you
> suggested... some modules didn't load.
> 
> ubuntu@ubuntu:~$ modprobe i2c-core
> ubuntu@ubuntu:~$ modprobe i2c-algo-bit
> ubuntu@ubuntu:~$ modprobe saa7111
> modprobe: FATAL: Module saa7111 not found.
Means that this module is not included in the kernel.

> ubuntu@ubuntu:~$ modprobe saa7185
> modprobe: ERROR: could not insert 'saa7185': Operation not permitted
When you see "operation not permitted" it could mean that you do not 
have sufficient rights. Reading your commandline I would guess that you 
are not root. Try adding sudo infrot the command that did not work:
sudo modprobe saa7185
and:
sudo modprobe zr36060

My (and googles) other ideas about the problem sound strange and more 
work like disabling secure boot.

> ubuntu@ubuntu:~$ modprobe zr36060
> modprobe: ERROR: could not insert 'zr36060': Operation not permitted
> ubuntu@ubuntu:~$ insmod saa7111.ko
> insmod: ERROR: could not load module saa7111.ko: No such file or directory
> ubuntu@ubuntu:~$ insmod saa7185
> insmod: ERROR: could not load module saa7185: No such file or directory
> ubuntu@ubuntu:~$ insmod saa7185.ko
> insmod: ERROR: could not load module saa7185.ko: No such file or directory
> ubuntu@ubuntu:~$ insmod zr36060.ko
> insmod: ERROR: could not load module zr36060.ko: No such file or directory
> 
> Thoughts?
> 
> On 4/22/21, Bernhard Praschinger <[email protected]> wrote:
>> Hallo,
>>
>> William Lum wrote:
>>> Hi,
>>>
>>> I looked in /proc/scsi/advansys and there is a file 13:
>>>
>>> AdvanSys SCSI 3.4: PCI Ultra: IO 0xAE00-0xAE0F, IRQ 0x15
>>>
>>> Device Information for AdvanSys SCSI Host 13:
>>> Target IDs Detected: 2, (2=Host Adapter)
>> [...]
>>> Does this mean it's loaded?
>> It looks at least good. It means that the PCI Switch on the card works.
>>
auf hoffentlich bald,

Berni the Chaos of Woodquarter

Email: [email protected]
www: http://www.lysator.liu.se/~gz/bernhard