Re: Re: Hardware encoding

Vladimir M <[email protected]>
Newsgroups gmane.comp.video.mplayer.user.dvb
Message-ID <[email protected]> 
> so you always use software decoding, right ?

If I dont specify:

Opening video decoder: [mpegpes] MPEG 1/2 Video passthrough
no luck, then it says
Opening video decoder: [libmpeg2] MPEG 1/2 Video decoder libmpeg2-v0.4.0b
 
So, always software.

> read the line above: mplayer dropped more than 50 frames and is about to 
> 0.5 desync between
> audio and video. This means that timestamps are too far apart, 
> consequently soon you begin to see
> sound but video slows down until it freezes completely. This is what 
> causes all these problems.
> It's a problem that to me happens when watching disturbed channels, but 
> I was unable to fix it yet

dvbscale filter cannot display resolution that gives DVB-card, right?
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.