Re: Support for New Zealand H.264 DVB-T streams

> Il Wednesday 12 December 2007 07:41:52 Igor ha scritto:
> > > My biggest problem was realizing I needed to include the PMT
> > > information in the channels.conf file as this doesn't appear to
> > > be documented anywhere.
> >
> > from MPlayer DOCs
> > http://www.mplayerhq.hu/DOCS/HTML-single/en/MPlayer.html
> > In your audio and video fields you can use an extended syntax:
> > ...:pid[+pid]:... (for a maximum of 6 pids each); in this case
> > MPlayer will include in the stream all the indicated pids, plus pid
> > 0 (that contains the PAT). You are encouraged to include in each
> > row the PMT pid for the corresponding channel (if you know it). You
> > can also specify 8192, this will select all pids on this frequency
> > and you can then switch between the programs with TAB. This might
> > need more bandwidth, though cheap cards always transfer all
> > channels at least to the kernel so it does not make much of a
> > difference for these. Other possible uses are: televideo pid,
> > second audio track, etc.
> 
> a quick fix is to always pid 8192 and use TAB to cycle through
> channels

yes, but this method can't work with dvb-s2 modulation yet.


regards
Igor