Re: On HD Channels no audio!

Carl Eugen Hoyos wrote:
> Hi!
> 
> On Sun, 25 Oct 2009, Raena Lea-Shannon wrote:
> 
>> I did not add the audio pid that kaffeine uses to channels.conf.
> 
> And you were still surprised that mplayer didn't play audio?
> 
>> Here is the relevant line of that file for ABC HDTV from kaffeine.
>>
>> TV|ABC
>> HDTV|2314(2)|2315(eng)(ac3),|2316|544|545|Terrestrial|543500|0|v|34|-1|64|-1|7|8|16|0|20|||4112| 
>>
>>
>>
>> Here is the mplayer channels.conf file for ABC HDTV
>>
>> ABCHDTV:543500000:INVERSION_AUTO:BANDWIDTH_7_MHZ:FEC_3_4:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_16:HIERARCHY_NONE:2314:0:544: 
>>
> 
> HIERARCHY_NONE:2314:2315+10+2316:
> 
> Where I wrote "10" you should instead add the PMT/PAT of this program 
> (scan -c prints it behind "pmt_pid").
> I wrote "2316" to show you the possibility to add further audio streams
> (also shown by scan -c if available).
> 
> As an alternative, you can just write "8192" meaning "all streams of all
> programs". TAB allows you to change from one program to the next (from the
> same transponder).
> 
> This is all explained in the DOCS, if you have suggestions for 
> documentation improvements, don't hesitate to send them (svn di)!
> 
> Carl Eugen
> 
> _______________________________________________
> MPlayer-dvb mailing list
> [email protected]
> https://lists.mplayerhq.hu/mailman/listinfo/mplayer-dvb
> 
Works fine with
HIERARCHY_NONE:2314:2315:8192

If you have the patience can you explain why my scan -c did not work and 
I will do some more reading and look at those DOCS.

Thanks again.