Re: DVB-C and channels.conf

 From the log I see mplayer has tuned and is reading both audio and 
video from the stream.

Can you run
mplayer -dumpstream -dumpfile file.ts dvb://

and verify that file.ts is not empty and playable, please?

Thanks,
    Nico
Andreas Matthias wrote:

>Nico wrote:
>
>  
>
>>Oops 2)
>>
>>in dvb_tune.c, function  dvb_tune change
>>
>>-if(freq > 100000000)
>> -   {
>>  -      tune_it(priv->fe_fd, 0, freq, 0, 0, tone, specInv, diseqc,
>>         modulation, HP_CodeRate, TransmissionMode, guardInterval,
>>         bandWidth);
>>  -  }
>>
>>with
>>
>>+if(freq > 100000000)
>>+  {
>> +     tune_it(priv->fe_fd, 0, freq, srate, 0, tone, specInv, diseqc,
>> modulation, HP_CodeRate, TransmissionMode, guardInterval, bandWidth);
>>+    }
>>
>>
>>Does it work now?
>>    
>>
>
>No, not yet. :-(
>
>The output of mplayer is very long, so I zipped it and attached
>it as a real attachment. I hope attachments go through on this
>list.
>
>Ciao
>Andreas
>
>  
>
>------------------------------------------------------------------------
>
>_______________________________________________
>Mplayer-dvb mailing list
>[email protected]
>http://mplayerhq.hu/mailman/listinfo/mplayer-dvb
>  
>