Re: mplayer hangs after a few movies

hello

now i switched to unbuntu/debian-linux and still have the problem.
BUT i have to correct myself - mplayer also hangs with one file,
if i start it often enough (around 10 times). it has nothing to do
with the enqueuing of more files.

then i thought maybe the sound played over oss is the problem and
used '-ao mpegpes', but (as always) the same effect.

some more information:
card: technotrend (philips SAA7146 rev01)
firmware: dvb-ttpci-01.fw-261c
tv-format: pal

here an mplayer-output. after a few working files, this movie didn't start
---BEGIN-----------------------------------------------------------------
ll@linux:/home/install/MPlayer-1.0pre6 $ ./mplayer -vo mpegpes -ao oss 
-v /home/ll/test.mpg

MPlayer 1.0pre6-3.3.4 (C) 2000-2004 MPlayer Team
CPU: Intel Pentium 4/Xeon/Celeron Northwood (Family: 8, Stepping: 4)
Detected cache-line size is 64 bytes
CPUflags:  MMX: 1 MMX2: 1 3DNow: 0 3DNow2: 0 SSE: 1 SSE2: 1
Compiled with runtime CPU detection - WARNING - this is not optimal!
To get best performance, recompile MPlayer with 
--disable-runtime-cpudetection.

CommandLine: '-vo' 'mpegpes' '-ao' 'oss' '-v' '/home/ll/test.mpg'
get_path('font/font.desc') -> '/home/ll/.mplayer/font/font.desc'
font: can't open file: /home/ll/.mplayer/font/font.desc
font: can't open file: /usr/share/mplayer/font/font.desc
Using MMX (with tiny bit MMX2) Optimized OnScreenDisplay
Using Linux hardware RTC timing (1024Hz).
get_path('input.conf') -> '/home/ll/.mplayer/input.conf'
Can't open input config file /home/ll/.mplayer/input.conf: Datei oder 
Verzeichnis nicht gefunden
Can't open input config file /usr/etc/mplayer/input.conf: Datei oder 
Verzeichnis nicht gefunden
Falling back on default (hardcoded) input config
get_path('test.mpg.conf') -> '/home/ll/.mplayer/test.mpg.conf'
Playing /home/ll/test.mpg.
[file] File size is 4823044 bytes
STREAM: [file] /home/ll/test.mpg
STREAM: Description: File
STREAM: Author: Albeu
STREAM: Comment: based on the code from ??? (probably Arpi)
Checking for YUV4MPEG2
ASF_check: not ASF guid!
Checking for Nullsoft Streaming Video
Checking for NuppelVideo
Checking for REAL
Checking for SMJPEG
Searching demuxer type for filename /home/ll/test.mpg ext: .mpg
Checking for MOV
Checking for VIVO
header block 1 size: 0
Checking for PVA
Checking for MPEG-TS...
TRIED UP TO POSITION 66361, FOUND 47, packet_size= 0, SEEMS A TS? 0
Checking for LMLM4 Stream Format
Invalid packet in LMLM4 stream: ch=0 size=1140851736
LMLM4 Stream Format not found
system stream synced at 0xD (0)!
==> Found video stream: 0
==> Found audio stream: 0
MPEG Stream reached EOF
ds_fill_buffer: EOF reached (stream: video)
MPEG-PS file format detected.
Searching for sequence header... OK!
VIDEO:  MPEG2  720x576  (aspect 2)  25,000 fps  4000,0 kbps (500,0 kbyte/s)
[V] filefmt:2  fourcc:0x10000002  size:720x576  fps:25,00  ftime:=0,0400
get_path('sub/') -> '/home/ll/.mplayer/sub/'
get_path('default.sub') -> '/home/ll/.mplayer/default.sub'
==========================================================================
Opening audio decoder: [mp3lib] MPEG layer-2, layer-3
dec_audio: Allocating 4608 + 65536 = 70144 bytes for output buffer.
mp3lib: made decode tables with MMX optimization
mp3lib: using MMX optimized decore!
MP3lib: init layer2&3 finished, tables done
MPEG 1.0, Layer II, 44100 Hz 192 kbit Stereo, BPF: 627
Channels: 2, copyright: No, original: No, CRC: No, emphasis: 0
AUDIO: 44100 Hz, 2 ch, 16 bit (0x10), ratio: 24000->176400 (192,0 kbit)
Selected audio codec: [mp3] afm:mp3lib (mp3lib MPEG layer-2, layer-3)
==========================================================================
Opening /dev/dvb/adapter0/video0+audio0
==========================================================================
Opening video decoder: [mpegpes] MPEG 1/2 Video passthrough
VDec: vo config request - 720 x 576 (preferred csp: Mpeg PES)
Trying filter chain: vo
VDec: using Mpeg PES as output csp (no 0)
Movie-Aspect is 1,33:1 - prescaling to correct movie aspect.
VO Config (720x576->768x576,flags=0,'MPlayer',0x4D504553)
VO: [mpegpes] 720x576 => 768x576 Mpeg PES
VO: Description: Mpeg-PES to DVB card
VO: Author: A'rpi
Selected video codec: [mpegpes] vfm:mpegpes (Mpeg PES output (.mpg or Dxr3/DVB 
card))
==========================================================================
Checking audio filter chain for 44100Hz/2ch/16bit -> 44100Hz/2ch/16bit...
[libaf] Adding filter dummy
[dummy] Was reinitialized, rate=44100Hz, nch = 2, format = 0x00000001 and bps 
= 2
AF_pre: af format: 2 bps, 2 ch, 44100 hz, little endian signed int
AF_pre: 44100Hz 2ch Signed 16-bit (Little-Endian)
ao2: 44100 Hz  2 chans  Signed 16-bit (Little-Endian)
audio_setup: using '/dev/dsp' dsp device
audio_setup: using '/dev/mixer' mixer device
audio_setup: using 'pcm' mixer device
audio_setup: sample format: Signed 16-bit (Little-Endian) (requested: Signed 
16-bit (Little-Endian))
audio_setup: using 2 channels (requested: 2)
audio_setup: using 44100 Hz samplerate (requested: 44100)
audio_setup: frags:  16/16  (4096 bytes/frag)  free:  65536
AO: [oss] 44100Hz 2ch Signed 16-bit (Little-Endian) (2 bps)
AO: Description: OSS/ioctl audio output
AO: Author: A'rpi
Building audio filter chain for 44100Hz/2ch/16bit -> 44100Hz/2ch/16bit...
[dummy] Was reinitialized, rate=44100Hz, nch = 2, format = 0x00000001 and bps 
= 2
[dummy] Was reinitialized, rate=44100Hz, nch = 2, format = 0x00000001 and bps 
= 2
Starting playback...
*** [vo] Exporting mp_image_t, 720x576x0bpp RGB packed, 0 bytes
A:   0,5 V:   0,6 A-V: -0,049 ct: -0,002   4/  4 ??% ??% ??,?% 0 0
---END-------------------------------------------------------------------

at that point the process is shown as sleeping
AND when i press ctrl-c (because it did not react on pressing 'q') mplayer
prints ...

---BEGIN-----------------------------------------------------------------
MPlayer interrupted by signal 2 in module: decode_video
Uninit audio filters...
[libaf] Removing filter dummy
uninit audio: mp3lib
uninit video: mpegpes
---END-------------------------------------------------------------------


/var/log/messages looks like that
---BEGIN-----------------------------------------------------------------
Dec 28 16:21:18 localhost kernel: Linux video capture interface: v1.00
Dec 28 16:21:19 localhost kernel: saa7146: register extension 'dvb'.
Dec 28 16:21:19 localhost kernel: ACPI: PCI interrupt 0000:02:0a.0[A] -> GSI 
22 (level, low) -> IRQ 209
Dec 28 16:21:19 localhost kernel: saa7146: found saa7146 @ mem e0aae800 
(revision 1, irq 209) (0x13c2,0x0000).
Dec 28 16:21:19 localhost kernel: DVB: registering new adapter 
(Siemens/Technotrend/Hauppauge PCI rev1.3).
Dec 28 16:21:19 localhost kernel: ves1x93: Detected ves1893a rev2
Dec 28 16:21:19 localhost kernel: DVB: registering frontend 0:0 (VES1893)...
Dec 28 16:21:19 localhost kernel: Siemens/Technotrend/Hauppauge PCI rev1.3 
adapter 0 has MAC addr = 00:d0:5c:00:7a:c4
Dec 28 16:21:20 localhost kernel: gpioirq unknown type=0 len=0
Dec 28 16:21:20 localhost kernel: DVB: AV7111(0) - firm f0240009, rtsl 
b0250018, vid 71010068, app 8000261c
Dec 28 16:21:20 localhost kernel: DVB: AV7111(0) - firmware supports CI link 
layer interface
Dec 28 16:21:20 localhost kernel: av7110(0): adac type set to 0
Dec 28 16:21:20 localhost kernel: videodev: "av7110" has no release callback. 
Please fix your driver for proper sysfs support, see 
http://lwn.net/Articles/36850/
Dec 28 16:21:20 localhost kernel: saa7146_vv: saa7146 (0): registered device 
video0 [v4l2]
Dec 28 16:21:20 localhost kernel: av7110: found av7110-0.
Dec 28 16:21:20 localhost input.agent[6451]:      evbug: blacklisted
Dec 28 16:21:20 localhost input.agent[6451]:      evdev: already loaded
Dec 28 16:21:20 localhost input.agent[6486]:      evbug: blacklisted
Dec 28 16:21:20 localhost input.agent[6486]:      evdev: already loaded
Dec 28 16:21:20 localhost kernel: saa7146: register extension 'budget dvb'.
Dec 28 16:21:20 localhost kernel: saa7146: register extension 'budget_ci dvb'.
Dec 28 16:21:20 localhost kernel: saa7146: register extension 'budget dvb /w 
video in'.
Dec 28 16:21:20 localhost kernel: usbcore: registered new driver 
Technotrend/Hauppauge USB-Nova
Dec 28 16:21:20 localhost kernel: usbcore: registered new driver ttusb-dec
--------------------------------------------------------------------------

thx
lukas