Re: 2.6.11 Problem with latest mga_vid

SOLVED.
Thank you! It is working perfectly.
Todor


Ferdinand O. Tempel wrote:

>On Mon, 2005-03-21 at 11:23 +0100, Todor Dobrikov wrote:
>  
>
>>Hello,
>>I' managed to compile the module and to insert it in the kernel but 
>>after that when I run mga_vid_test it says that the driver is not loaded.
>>dmes:
>>Matrox MGA G200/G400/G450/G550 YUV Video interface v2.01 (c) Aaron 
>>Holtzman & A'rpi
>>mga_vid: Found MGA G550 at 0000:02:00.0 [0000:02:00.0]
>>mga_vid: MMIO at 0xe28d8000 framebuffer: 0xE2000000
>>mga_vid: OPTION word: 0x400A1520  mem: 0x05  SDRAM
>>mga_vid: detected RAMSIZE is 32 MB
>>mga_vid: 1 supported cards found
>>mga_vid: using major: 83 (assigned or default!)
>>
>>This is because I do not have /dev/mga_vid. I am using *pure* udev on 
>>2.6.11 and probably this is causing the problem. I saw that there is 
>>*partial* support for udev. What should I do to bring it up?
>>    
>>
>
>How about creating the required device node?
>
>`mknod /dev/mga_vid c 83 0`, as it's documented in the mga_vid.c source.
>
>I.e. do by hand what udev does for you. Either that, or wait for us to
>finish up udev support.
>
>Ferdinand O. Tempel
>
>_______________________________________________
>MPlayer-matrox mailing list
>[email protected]
>http://mplayerhq.hu/mailman/listinfo/mplayer-matrox
>
>  
>

_______________________________________________
MPlayer-matrox mailing list
[email protected]
http://mplayerhq.hu/mailman/listinfo/mplayer-matrox