Re: Write multi-part file

Hello Piotr,
Thanks for the advice. This helped. I figured it out now.
I see it works in fact quite like I have imagined it.

Chris


Am 11.05.2014 19:34, schrieb Piotr Stanczyk:
> Hi Christopher,
>
> I'll make sure we expand the documentation to cover multipart files,
> however, for the time being I'd like to point you to the unit tests that
> are part of the distribution.
> There you will find example of writing and reading multipart files that
> should serve your needs.
>
> Hope that helps
>
> Piotr
>
>
>
> On 11 May 2014 09:05, Christopher Kappe <[email protected]
> <mailto:[email protected]>> wrote:
>
>     Hello,
>
>     I have read all the documentation that comes with OpenEXR and
>     searched the internet for hours but I just can't figure out
>
>     how to write multi-part exr files.
>
>     It is stated that this and deep images are new to v2 of the standard
>     but the documentation only covers those deep images.
>     So could someone please, please, please give me a hint on how to
>     generate such files?
>     Best would be a compilable cpp file as one can find for the other
>     "exr use cases".
>     I imagine is has just another loop around the
>     for( x=0...)
>        for( y=0...)
>
>     like
>     for( part=0...)
>        addNewPart()
>        ...
>
>     Hoping for some help,
>     Chris
>
>     _________________________________________________
>     Openexr-devel mailing list
>     [email protected] <mailto:[email protected]>
>     https://lists.nongnu.org/__mailman/listinfo/openexr-devel
>     <https://lists.nongnu.org/mailman/listinfo/openexr-devel>
>
>