Re: Running a single test

There may be a way to achieve this, but its been a while since I had a
look.  Are you building the library with CMake or autoconf?


On 1 October 2015 at 12:59, Mathieu Malaterre <[email protected]> wrote:

> Dear all,
>
> I am trying to investigate the remaining issue with OpenEXR 2.2.0 on
> big endian arch. How am I supposed to run a single test.
>
> Current log states:
>
> $ cat IlmImfTest.log
> [...]
> =======
> Running testSharedFrameBuffer
> Testing reading from and writing to files using
> multiple threads and a shared framebuffer
> number of threads: 0
> channels RGBA, compression 0, writing reading comparing
> channels RGB, compression 0, writing reading comparing
> channels A, compression 0, writing reading comparing
> channels RB, compression 0, writing reading comparing
> channels RGBA, compression 1, writing reading comparing
> channels RGB, compression 1, writing reading comparing
> channels A, compression 1, writing reading comparing
> channels RB, compression 1, writing reading comparing
> channels RGBA, compression 2, writing reading comparing
> channels RGB, compression 2, writing reading comparing
> channels A, compression 2, writing reading comparing
> channels RB, compression 2, writing reading comparing
> channels RGBA, compression 3, writing reading comparing
> channels RGB, compression 3, writing reading comparing
> channels A, compression 3, writing reading comparing
> channels RB, compression 3, writing reading comparing
> channels RGBA, compression 4, writing reading comparing
> channels RGB, compression 4, writing reading comparing
> channels A, compression 4, writing reading comparing
> channels RB, compression 4, writing reading comparing
> channels RGBA, compression 5, writing reading comparing
> channels RGB, compression 5, writing reading comparing
> channels A, compression 5, writing reading comparing
> channels RB, compression 5, writing reading comparing
> channels RGBA, compression 6, writing reading comparing
> channels RGB, compression 6, writing reading comparing
> channels A, compression 6, writing reading comparing
> channels RB, compression 6, writing reading comparing
> channels RGBA, compression 7, writing reading comparing
> channels RGB, compression 7, writing reading comparing
> channels A, compression 7, writing reading comparing
> channels RB, compression 7, writing reading comparing
> channels RGBA, compression 8, writing reading comparing
> lt-IlmImfTest: compareDwa.cpp:122: void compareDwa(int, int, const
> Imf_2_2::Array2D<Imf_2_2::Rgba>&, const
> Imf_2_2::Array2D<Imf_2_2::Rgba>&, Imf_2_2::RgbaChannels): Assertion
> `relError < .1' failed.
>
>
> There is almost no documentation for doing such trivial thing with
> `test-driver`. I cannot re-run from the begining this machine is way
> too slow ...
>
> Thanks much
>
> _______________________________________________
> Openexr-devel mailing list
> [email protected]
> https://lists.nongnu.org/mailman/listinfo/openexr-devel
>

_______________________________________________
Openexr-devel mailing list
[email protected]
https://lists.nongnu.org/mailman/listinfo/openexr-devel