Re: EXR layer naming conventions

On Thu, 28 Jun 2007 21:19:41 +0200, Jim Hourihan <[email protected]> wrote:

> Hi All, I was wondering how people are using EXR layers. Especially
> how the layers are being named and if there are any defacto standards
> out there.

I'm not sure about standards, but exrTrader for LightWave uses the buffer names as defined by Lightwave itself.

They are either RGB or just a single named channel, the exception being the motion buffer.

Here is a list:

R G B A Z
Raw Colour: Raw.R .G .B
Reflection Colour: Refl.R .G .B
Diffuse Colour: Diff.R .G .B
Specular Colour: Spec.R .G .B
Backdrop Colour: Backdrop.R .G .B
PreEffect Colour: PreEffect.R .G .B

Single channels:
Special, Luminosity, Diffuse, Specularity, Reflectivity, Transparency, Shading, Shadow, Geometry, DiffShade, SpecShade

Motion.X .Y

I'd be eager to have some standardization out there (as far as that is possible with the different kinds of render outputs). exrTrader supports channel naming presets, so I could add a new one any time.

Cheers,
Mike

-- 
db&w Bornemann & Wolf GbR
Dagmar Bornemann, Michael Wolf
Seyffer Str. 34
70197 Stuttgart
Germany

http://www.db-w.com
http://www.infinimap.com
tel: +49 (711) 664 525-0
fax: +49 (711) 664 525-1
icq: 252887990
skype: lupus_lux