a stupid question on speed on 68VZ328

Hi all,
   There is a stupid question about picogui's speed.
   We had head there are many people had use picogui on uClinux based on 
68VZ328 in 33MHZ processor.
   
   We had develop a board that based 68VZ328, and uClinux 2.4.17 kernel, 
run in ROM. And build the picogui, modify little codes for support 
chinese(GB2312).when run in PC, it's ok, but when run on our board it seem 
too slow. there are /proc/cpuinfo of uClinux, Does anybody tell me the 
speed of picogui run on other board ??
 CPU:            MC68VZ328
 MMU:            none
 FPU:            none
 Clocking:       18.2MHz
 BogoMips:       2.28
 Calibration:    1142400 loops
                                sanit
                            www.handinfo.com

_________________________________________________________________
璐逛杞 MSN Explorer:   http://explorer.msn.com/lccn/  



-------------------------------------------------------
This SF.net email is sponsored by: Scholarships for Techies!
Can't afford IT training? All 2003 ictp students receive scholarships.
Get hands-on training in Microsoft, Cisco, Sun, Linux/UNIX, and more.
www.ictp.com/training/sourceforge.asp