status of the arm-linux port

Hi!

On http://www.picogui.org/ports.php, 3 arm-linux configurations are declared as "definitely working", however I get an assembler error when compiling against arm, which doesn't look good:

/home/fritz/arm/arm-linux/bin/gcc -DHAVE_CONFIG_H -I. -I. -I.. -I../include -I../include -I/usr/include -I/usr/include/SDL -D_REENTRANT -O2 -g -Wp,-MD,.deps/sdlinput.pp -c sdlinput.c -o sdlinput.o
echo timestamp > sdlinput.lo
/bin/sh ../libtool --mode=compile /home/fritz/arm/arm-linux/bin/gcc -DHAVE_CONFIG_H -I. -I. -I.. -I../include -I../include -I/usr/include -I/usr/include/SDL -D_REENTRANT    -O2 -g -c ttykb.c
/home/fritz/arm/arm-linux/bin/gcc -DHAVE_CONFIG_H -I. -I. -I.. -I../include -I../include -I/usr/include -I/usr/include/SDL -D_REENTRANT -O2 -g -Wp,-MD,.deps/ttykb.pp -c ttykb.c -o ttykb.o
/tmp/cckWIEoP.s: Assembler messages:
/tmp/cckWIEoP.s:1037: Error: bad instruction `btsl r3,[r1,r2,asl#2]'
make[3]: *** [ttykb.lo] Error 1
make[3]: Leaving directory `/home/fritz/arm/src/picogui-0.44/pgserver/input'
make[2]: *** [all-recursive] Error 1
make[2]: Leaving directory `/home/fritz/arm/src/picogui-0.44/pgserver'
make[1]: *** [all-recursive-am] Error 2
make[1]: Leaving directory `/home/fritz/arm/src/picogui-0.44/pgserver'
make: *** [src/picogui-0.44/pgserver/pgserver] Error 2

I configure pgserver like this:
./configure --prefix=$(ARM_ROOT)/ramdisk/target/usr --with-sdl-prefix=/usr/ --target=arm-linux --host=arm-linux --with-extra-ipath=/usr/include

Thanks a lot for any comments,

Roland Seuhs



-------------------------------------------------------
This SF.NET email is sponsored by:
SourceForge Enterprise Edition + IBM + LinuxWorld = Something 2 See!
http://www.vasoftware.com