Re: Transcode segfaulting on Fedora 10 x64.

2009/5/27 Ambrogio De Lorenzo <[email protected]>

> Il giorno lun, 25/05/2009 alle 22.37 +0200, Francesco Romani ha scritto:
>
> > try using -y null and letting it work. Doing like that transcode would
> > waste some of your CPU time and will not produce anything as output,
> > BUT! if you're facing the same avilib problem outlined above, you should
> > NOT get a segfault. Transcode should shut down cleanly.
> with -y null transcode exit ok
>
> > Please provide a backtrace. Get it following the instructions here:
> > http://www.transcoding.org/cgi-bin/transcode?Reporting_Crashes
> > but use HG instead CVS!.
> I used the 1.1.0 from the official site and recompiled
> this is the backtrace
>
> gdb -q transcode
> (gdb) run  transcode -H 10 -a 0 -x vob,null
> -i /dvdrip-data/CosiFanTutte_SecondoNoi/vob/001/ -w 900,50 -c 1-50 -b
> 128,0,2 --a52_drc_off -f 25.000 -j 0,32,0,32 -Y -20,0,-20,0 -B 47,38,8
> -R 1 -y xvid4,null -o /dev/null -q
> 2
> Starting program: /opt/transcode/bin/transcode transcode -H 10 -a 0 -x
> vob,null -i /dvdrip-data/CosiFanTutte_SecondoNoi/vob/001/ -w 900,50 -c
> 1-50 -b 128,0,2 --a52_drc_off -f 25.000 -j 0,32,0,32 -Y -20,0,-20,0 -B
> 47,38,8 -R 1 -y xvid4,null -o /dev/null -q 2
> [Thread debugging using libthread_db
>
> [..]


The same here, with -y null it does not segfault.

Is there any workaround for this at the moment? Any other parameters I could
use or perhaps use the version in the cvs?

Thanks
Vini