Re: Bah! How do I change channels?
Devin Heitmueller <[email protected]>
| Newsgroups | gmane.linux.drivers.video-input-infrastructure,gmane.comp.video.video4linux |
|---|---|
| Message-ID | <[email protected]> |
On Fri, Jun 26, 2009 at 1:19 PM, Robert Krakora<[email protected]> wrote: > I had ran into this before with the KWorld a few months back. > However, whatever problem existed that forced me to add > "no_poweroff=1" to modprobe.conf for the em28xx module has went away. > I have been able to use v4l-ctl or ivtv-tune without any problems to > tune analog channels over cable. Well, bear in mind that if you run v4l-ctl *after* the program is streaming it should work. However, if you run v4l-ctl and then try to stream I suspect it will fail. If it's working, then perhaps I should take a look at the power management code in em28xx/xc2028 since I don't know why it would work (and perhaps the tuner is *not* being powered down like it should be). Devin -- Devin J. Heitmueller - Kernel Labs http://www.kernellabs.com -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html