Re: [PATCH 1/4] soc-camera: tw9910: hsync_ctrl can control from platform

Kuninori Morimoto <[email protected]>
Newsgroups gmane.comp.video.video4linux
Message-ID <u1vmhx20t.wl%[email protected]> 
Dear Guennadi

> Before reviewing the code - why is this needed?

Now I have new board which have tw9910.
and the start position is not same as MigoR.
(MigoR need +0x100, my new board needs +0xb0)

I'm not sure why (is it depend on LCDC size ?).
Datasheet doesn't have detail explain.

Best regards
--
Kuninori Morimoto
 

--
video4linux-list mailing list
Unsubscribe mailto:[email protected]?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.