Re: support for hauppauge wintv-hvr 950Q

Greetings,
Yes, I rebooted after installing the code.  I do see the device now, but it was odd because I did not see it before (and I rebooted numerous times).
Thanks!



________________________________
From: Devin Heitmueller <[email protected]>
To: Muppet Man <[email protected]>
Cc: [email protected]
Sent: Sat, March 13, 2010 11:31:30 AM
Subject: Re: support for hauppauge wintv-hvr 950Q

On Sat, Mar 13, 2010 at 11:50 AM, Muppet Man <[email protected]> wrote:
> Greetings all,
> I purchased a hauppauge wintv-hvr 950Q.  I downloaded and installed the lastest drivers from the v4l website.
>
> When attempting to use with TVtime, the only "video" device I can find is my webcam.
> When running lsusb, this is what I get:

Hello,

Did you reboot after installing the code?  Did you install the code
using the instructions at http://linuxtv.org/repo?

After the device is plugged in, you should see a new /dev/video device
appear.  If not, then the driver did not load.

Devin

-- 
Devin J. Heitmueller - Kernel Labs
http://www.kernellabs.com



      
--
video4linux-list mailing list
Unsubscribe mailto:[email protected]?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list