Re: (no subject)

Michael,

Take a look at examples.reinvite. ReinviteTest.java
You have a template there for multiplexing requests based on provider.
You can register a single listener with the stack and multiplex to many 
sublisteners using the provider to route requests.

Hope that helps

Ranga

Michalis Michail wrote:

>Hello again 
>
>thanks for the previus response but i havent figure out what i am supposed to
>do yet.Anyways i have modified the \jain-sip-1.2\src\examples\simplecallsetup
>shootist example as a runnable object so it can be runned as a thread.Each UAC
>sends a register message then cleans up and the thread dies.So i can have
>multiple UACs running in different threads.The problem is that when i try to
>repeat the loop again and create the same number of UAC threads only one of
>them  initialize properly and the rest give a ToManyListenersException .Is
>there a reason why this is happenning,since the first loop starts up
>ok.Considering the fact that each UAC is a different thread,and every thread
>before it dies cleans up everything ,its very wird.I even tried to put the
>loop in a threa but i got the same results.I have attached the code of the UAC
>if this is can help.Thanks for answering all my question so far.
>
>Michael   
>
>  
>
>------------------------------------------------------------------------
>
>_______________________________________________
>nist-sip mailing list
>[email protected]
>http://www-x.antd.nist.gov/mailman/listinfo/nist-sip
>  
>


-- 
M. Ranganathan 

Advanced Networking Technologies Division,
National Institute of Standards and Technology (NIST),
100 Bureau Drive, Stop 8920, Gaithersburg, MD 20899. 
tel:301 975 3664 , fax:301 590 0932 http://w3.antd.nist.gov/
Advanced Networking Technologies For the People!