Re: Dialing PSTN no from application...
"Jeroen van Bemmel" <[email protected]>
| Newsgroups | gmane.comp.voip.nist-sip |
|---|---|
| Message-ID | <004001c6ed19$20257990$0601a8c0@BEMBUSTER> |
Abu, >From the trace it appears you have NAT. X-Pro supports STUN, and uses IP address 192.168.0.17 while in both other traces (unclear which one is your application) 192.168.6.115 / 192.168.6.110 is used as Contact. X-Pro then manages to receive RTP on 192.168.0.17, while in both other cases it flows to 59.124.119.82 (strange address?) Another difference is that X-Pro negotiates codec G.729, while both others use G.711 Regards, Jeroen Abu M. Muttalib wrote: >> Hi, >> >> I am using an application to dial a PSTN no. Though I am getting the >> 200 OK response, I am not able to hear anything. >> >> In the same environment, with same user ID and password, I tried to >> call the PSTN no from XPro and was able to dial successfully. >> >> I am not able to figure out why I am not able to dial PSTN no from >> application. >> >> I am attaching the logs for both the scenarios. Its ethereal capture >> of SIP packets. >> >> Any help or pointer in appropriate direction will be appreciated. >> >> Thanks and regards, >> Abu. >> > > > >> _______________________________________________ >> nist-sip mailing list >> [email protected] >> http://www-x.antd.nist.gov/mailman/listinfo/nist-sip