Re: processing a delay value in creating a response

Hi Park,

This is a SHOULD and hence is not a mandatory part of the spec. You can 
compute the delay in your application as the diff between the time you 
see the request in your application and the time you sendResponse. Its 
easy enough to do. I'll look into providing this support in the stack 
(but I have some other priorities at the moment so it will take a little 
while).

Ranga

Young-Geun Park wrote:

> Hi, All
>
> the following is described in 8.2.6.1 rfc3261:
>
> If there is a delay in generating the response, the UAS
>
> SHOULD add a delay value into the Timestamp value in the response.
>
> This value MUST contain the difference between the time of sending of
>
> the response and receipt of the request, measured in seconds
>
> this part is omitted in implementation.
>
> so, I think that setting a delay value is needed in 
> SIPRequest.createResponse().
>
> is there any comment?
>
> Regards,
>
> Park
>
>------------------------------------------------------------------------
>
>_______________________________________________
>nist-sip mailing list
>[email protected]
>http://www-x.antd.nist.gov/mailman/listinfo/nist-sip
>  
>


-- 
M. Ranganathan 

Advanced Networking Technologies Division,
National Institute of Standards and Technology (NIST),
100 Bureau Drive, Stop 8920, Gaithersburg, MD 20899. 
tel:301 975 3664 , fax:301 590 0932 http://w3.antd.nist.gov/
Advanced Networking Technologies For the People!