Re: Separate Route headers instead of comma separated values in a single header

"M. Ranganathan" <[email protected]> Thu, 3 Jul 2008 21:00:55 -0400

Newsgroups	gmane.comp.voip.nist-sip
Message-ID	<[email protected]>

On Thu, Jul 3, 2008 at 7:14 PM, SanNxP <[email protected]> wrote:
> Hi,
>
> When I send a message thru the Jain-SIP stack, it is sending the route header
> like this
>
> Route: <sip:abc>, <sip:xyz>
>
> Is there a way I can force it to be separate headers like this:
>
> Route: <sip:abc>
> Route: <sip:xyz>
>
> What is the easiest way to do it?

No you cannot do that. The two are equivalent.


Ranga
>
> _______________________________________________
> nist-sip mailing list
> [email protected]
> http://www-x.antd.nist.gov/mailman/listinfo/nist-sip
>



-- 
M. Ranganathan