rtpengine module does not detect new nodes in table
David Cunningham via sr-users <[email protected]>
| Newsgroups | gmane.comp.voip.ser |
|---|---|
| Message-ID | <CAHGbP--XMFQ4F=LbU88QHZkuuj0VUTKL7nPDRegGNWKt4X1_Eg@mail.gmail.com> |
Hello,
We are using Kamailio 5.8.2 with the rtpengine module on Ubuntu 22.04. The
"rtpengine" table is used to define nodes, with a configuration like this:
modparam( "rtpengine", "db_url", DB_URL )
modparam( "rtpengine", "table_name", "rtpengine" )
modparam( "rtpengine", "setid_default", 1 )
It works fine if Kamailio is restarted after entries in the "rtpengine"
table are inserted or deleted, but new entries in the table aren't detected
automatically. Is there a way to configure Kamailio to detect them?
Thank you,
--
David Cunningham, Voisonics Limited
http://voisonics.com/
USA: +1 213 221 1092
New Zealand: +64 (0)28 2558 3782
__________________________________________________________
Kamailio - Users Mailing List - Non Commercial Discussions -- [email protected]
To unsubscribe send an email to [email protected]
Important: keep the mailing list in the recipients, do not reply only to the sender!