Re: rtpengine module does not detect new nodes in table

There's an RPC command for reloading rtpengine config:

https://www.kamailio.org/docs/modules/stable/modules/rtpengine.html#rtpengine.r.reload

Regards,
Kaufman

________________________________
From: David Cunningham via sr-users
Sent: Wednesday, April 23, 2025 4:55 PM
To: Kamailio (SER) - Users Mailing List
Cc: David Cunningham
Subject: [SR-Users] rtpengine module does not detect new nodes in table


CAUTION: This email originated from outside the organization. Do not click links or open attachments unless you recognize the sender and know the content is safe.

Hello,

We are using Kamailio 5.8.2 with the rtpengine module on Ubuntu 22.04. The "rtpengine" table is used to define nodes, with a configuration like this:

    modparam( "rtpengine", "db_url", DB_URL )
    modparam( "rtpengine", "table_name", "rtpengine" )
    modparam( "rtpengine", "setid_default", 1 )

It works fine if Kamailio is restarted after entries in the "rtpengine" table are inserted or deleted, but new entries in the table aren't detected automatically. Is there a way to configure Kamailio to detect them?

Thank you,

--
David Cunningham, Voisonics Limited
http://voisonics.com/<https://urldefense.com/v3/__http://voisonics.com/__;!!KWzduNI!ZdLfAmCE7Q_j-nlwkepzScbqd2y5y4MYuTtXwBhV-Hd-NoiLTmYB-0XaOErxWJh78fmsFHNDJvVclyTn9-JJljo$>
USA: +1 213 221 1092
New Zealand: +64 (0)28 2558 3782

__________________________________________________________
Kamailio - Users Mailing List - Non Commercial Discussions -- [email protected]
To unsubscribe send an email to [email protected]
Important: keep the mailing list in the recipients, do not reply only to the sender!