Re: Kamailio Dispatcher for Docker Asterisk

--network=host  no ?


On Tue, Jun 3, 2025 at 2:45 PM Fernando Lopes via sr-users <
[email protected]> wrote:

> Hello everyone,
> I have Kamailio running on port 5060, and I'm running Asterisk inside a
> Docker container. I'm trying to connect to Asterisk via port 5061. Could
> someone please advise what I should add to my dispatcher list?
> Currently, I have the dispatcher.list entry:
> 1 sip:10.0.0.5:5061;transport=tcp 0
>
> Here’s the network info for my Kamailio host (eth0 interface):
> inet 10.0.0.4/24 brd 10.0.0.255 scope global eth0
>
> And here are the relevant port mappings from Docker:
> 5038/tcp -> 0.0.0.0:5038
> 5060/tcp -> 0.0.0.0:5061
> 5060/udp -> 0.0.0.0:5061
> ...
> My main question:
> Is the dispatcher entry sip:10.0.0.5:5061;transport=tcp correct if
> Asterisk is listening on port 5061 in the container? Do I need to adjust
> anything on the Kamailio side or change the dispatcher entry format?
>
> Thanks in advance for any help!
> __________________________________________________________
> Kamailio - Users Mailing List - Non Commercial Discussions --
> [email protected]
> To unsubscribe send an email to [email protected]
> Important: keep the mailing list in the recipients, do not reply only to
> the sender!
>


-- 

*Antony*
[email protected]

__________________________________________________________
Kamailio - Users Mailing List - Non Commercial Discussions -- [email protected]
To unsubscribe send an email to [email protected]
Important: keep the mailing list in the recipients, do not reply only to the sender!