Re: adding codecs to rtpengine
Fred Posner via sr-users <[email protected]>
| Newsgroups | gmane.comp.voip.ser |
|---|---|
| Message-ID | <[email protected]> |
> On Jun 3, 2025, at 4:31 PM, Jeff Brower via sr-users <[email protected]> wrote: > > Hi all, > > Is there a documented procedure for adding codecs to rtpengine ? As I understand it so far, we would adapt rtpengine encoder and decoder interfaces to the voplib API (documented at https://github.com/signalogic/SigSRF_SDK/blob/master/codecs_readme.md), allowing use of voplib shared object libs. > > I've been searching (e.g. adding codecs to rtpengine site:kamailio.org) but have not found a step-by-step procedure yet. > > Thanks for any advice / guidance. > > -Jeff > I’d recommend looking at the documentation for RTPengine itself: https://rtpengine.readthedocs.io/en/latest/ As well as https://rtpengine.readthedocs.io/en/latest/transcoding.html#transcoding "The following codecs are supported by rtpengine: • G.711 (a-Law and µ-Law) • G.722 • G.723.1 • G.729 • Speex • GSM • iLBC • Opus • AMR (narrowband and wideband) • EVS (if supplied – see below) “ Fred Posner Tel: +1 (352) 664-3733 Alt: +1 (224) 334-3733 Contact info at https://fredp.xyz __________________________________________________________ Kamailio - Users Mailing List - Non Commercial Discussions -- [email protected] To unsubscribe send an email to [email protected] Important: keep the mailing list in the recipients, do not reply only to the sender!