multihoming & BYEs
Dustin Marquess via sr-users <[email protected]>
| Newsgroups | gmane.comp.voip.ser |
|---|---|
| Message-ID | <dc82a686-7117-41d5-a1e2-b2cdb570a630@Spark> |
All,
I've tried searching and have found similar posts before, but I have yet to find a real 'solution'.
I'm running Kamailio 6.0.1 & RTPEngine 13.3.1.7 (on a Linux VM) as a "SBC" (at home) using the config from:
https://github.com/voiceboys/sbcOS/blob/version_2.0/var/www/html/alpine/config/a0%3A36%3A9f%3Ae7%3A6a%3Ae2/etc/kamailio/kamailio.cfg
Except that I've added the following:
mhomed=1
modparam("rr", "force_send_socket", 1)
The SBC is dual-homed: one interface on the local LAN and another interface directly on the Internet/WAN (real public IP).
Everything works fine, EXCEPT if the remote end (the side on the WAN/Internet) hangs up first. If they do, the BYE never makes it past Kamailio to the local PBX and/or phone.
https://users.openser.narkive.com/1aK7n8Il/sr-multihomed-kamailio-and-enable-double-rr#post8 suggests to use $sht to save the information needed, but I have no clue where in the config to put that.
Any help would be greatly appreciated.
Thanks!
-Dustin
__________________________________________________________
Kamailio - Users Mailing List - Non Commercial Discussions -- [email protected]
To unsubscribe send an email to [email protected]
Important: keep the mailing list in the recipients, do not reply only to the sender!