Re: Why does $T(id_index) return 0 even though t_suspend() is executed successfully?
Daniel-Constantin Mierla via sr-users <[email protected]>
| Newsgroups | gmane.comp.voip.ser |
|---|---|
| Message-ID | <[email protected]> |
On 13.08.25 09:38, mm e via sr-users wrote:
> if(t_suspend())
> {
> xlog("L_NOTICE", "==> processing suspended in transaction [$T(id_index):$T(id_label)] ");
> } else {
> xlog("L_ERR", "t_suspend err");
> exit;
> }
>
> Sometimes, I get this log==> processing suspended in transaction [0:13614] "，as far as I know, 0 means that the value cannot be obtained. Executing t_continue(tindex, tlabel, rtname) with parameter 0 will fail.by the way, It's a question of probability.
The $T(id_index) should be ok with value 0, because it is the index of a
hash table slot. It might be that $T(id_label) is not set 0.
Can you run with debug=0 and see if the log messages give more details
about why it fails to continue?
Cheers, Daniel
--
Daniel-Constantin Mierla (@ asipto.com)
twitter.com/miconda -- linkedin.com/in/miconda
Kamailio Consultancy, Training and Development Services -- asipto.com
__________________________________________________________
Kamailio - Users Mailing List - Non Commercial Discussions -- [email protected]
To unsubscribe send an email to [email protected]
Important: keep the mailing list in the recipients, do not reply only to the sender!