Re: DMQ Status Flapping Between Active and Pending.

HI,

Thanks for the reply.

Yes, I already tried using *ngrep* and was able to see the *KDMQ* and *200
OK* messages.

However, when the status is *active*, the trace continues normally.
But when the status changes to *pending*, the trace stops and only resumes
once the status becomes *active* again.

On Mon, Oct 6, 2025 at 5:19 PM Henning Westerholt <[email protected]> wrote:

> Hello,
>
>
>
> first step is usually a packet trace, e.g. with ngrep. Have a look what is
> actually send and received for the DMQ protocol on the two Kamailio servers.
>
>
>
> Cheers,
>
>
>
> Henning
>
>
>
> *From:* satyaprakash ch via sr-users <[email protected]>
> *Sent:* Sunday, October 5, 2025 9:15 PM
> *To:* Kamailio (SER) - Users Mailing List <[email protected]>
> *Cc:* satyaprakash ch <[email protected]>
> *Subject:* [SR-Users] DMQ Status Flapping Between Active and Pending.
>
>
>
> Hi,
>
> I have *two Kamailio presence servers running version 5.8.4*. I am using
> *DMQ* to synchronize the active_watchers and presentity tables, but the
> synchronization does not seem to be occurring consistently.
>
> During investigation, I observed that the *DMQ status repeatedly toggles
> between **active** and **pending*, even though there is *no packet loss*
> detected.
>
> *Output of dmq_nodes:*
>
> {
>     host: 192.168.18.96
>     port: 5070
>     proto: *
>     resolved_ip:  192.168.18.96
>     status: pending
>     last_notification: 0
>     local: 0
> }
> {
>     host: 192.168.18.99
>     port: 5070
>     proto: *
>     resolved_ip:  192.168.18.99
>     status: active
>     last_notification: 0
>     local: 1
> }
>
> Any suggestions on what could cause this behavior would be greatly
> appreciated.
>

__________________________________________________________
Kamailio - Users Mailing List - Non Commercial Discussions -- [email protected]
To unsubscribe send an email to [email protected]
Important: keep the mailing list in the recipients, do not reply only to the sender!