Re: About permissions module

Hello,

I haven't looked at the code, but the name of the parameter suggests it
is about subnet addresses (e.g., 10.10.10.0/24), not full ip address
(e.g., 10.10.10.1/32).

Cheers,
Daniel

On 14.01.26 09:48, 赵斌 via sr-users wrote:
> I run kamailio 6.0.5 on debian 13,use mysql 8.4 as backend db.
> Use permissions module at kamailio,insert over 600 addrsses into
> address table,but i found max_subnets parameter at kamailio
> doc,default value is 512,my kamailio don`t set it.
> Reload address over 512,no error or warn at kamailio log,then try to
> dump address from memory,all address load.So this parameter is no use
> for permissions module,or this not for limit address to load to memory.
> Thank you very much. 
>


-- 
Daniel-Constantin Mierla (@ asipto.com)
twitter.com/miconda -- linkedin.com/in/miconda
Kamailio Consultancy, Training and Development Services -- asipto.com
Kamailio World Conference, May 7-8, 2026 - Berlin, Germany -- kamailioworld.com

__________________________________________________________
Kamailio - Users Mailing List - Non Commercial Discussions -- [email protected]
To unsubscribe send an email to [email protected]
Important: keep the mailing list in the recipients, do not reply only to the sender!