Best approach for 2-node active-active Kamailio setup

Hi ,

I am currently deploying a Kamailio SBC infrastructure with 2 nodes, one per datacenter, and I would like to set them up in active-active mode.

I have no experience yet with multi-node Kamailio setups and I would like to ask:

1. What is the recommended approach for a 2-node active-active Kamailio deployment today?

2. What modules or mechanisms should I use to synchronize state between the two nodes (calls, registrations, etc.)?

3. Are there any known issues or limitations I should be aware of before starting the configuration?

Any guidance or documentation pointers would be greatly appreciated.

Best regards,
__________________________________________________________
Kamailio - Users Mailing List - Non Commercial Discussions -- [email protected]
To unsubscribe send an email to [email protected]
Important: keep the mailing list in the recipients, do not reply only to the sender!