Re: Properities
"Tim Pezarro" <Tim_Pezarro-4W7cOCfLBmzY0TyS/[email protected]>
| Newsgroups | gmane.comp.web.canoo.webtest |
|---|---|
| Message-ID | <[email protected]_nt.nt.pmc-sierra.bc.ca> |
Eric,
What do you mean by set by user? If the property is dynamic and set during the run time, it should use this syntax: #{url}/test
There are several steps that will assign a dynamic value to a property. I am out ot the office until next week and do not have an example in front of me.
If you are still having trouble, send the part of your test where you are settng the property ${url}.
Cheers,
Tim Pezarro
Manager, Web Services
[email protected]
Phone: +1-604-415-6044
Cell: +1-604-762-1000
Fax: +1-604-415-6602
PMC-Sierra, Inc.
8555 Baxter Place
Burnaby, BC, Canada
V5A 4V7
----- Original Message -----
From: [email protected] <[email protected]>
To: [email protected] <[email protected]>
Sent: Fri Jul 01 13:38:40 2011
Subject: [Webtest] Properities
I have a couple of base url's to test. I have a property set by the user but when I go to do the webtest it isn't actually replaced. ex: ${url}/test
The url property is set by the user depending on what url they want to test. Can anyone shed some insight on this?_______________________________________________
WebTest mailing list
[email protected]
http://lists.canoo.com/mailman/listinfo/webtest