Re: Galeon 1.3.15 for x86-64 crashes

On Sat, 26 Jun 2004, Nicola wrote:

> I've just installed FC2 on my new AMD64 3200+.
> I am using the version for x86_64. Previously I was
> running fc1 for x86. I've installed your package for
> galeon:
> galeon-1.3.15-1.1.fc2.dag.x86_64.rpm
> all seems fine, but starting galeon is impossible. It
> just segfaults:
> galeon-bin[29699]: segfault at 0000003700000000 rip
> 00000037f03100da rsp 0000007fbffff060 error 4
> galeon-bin[30007]: segfault at 0000003700000000 rip
> 00000037f03100da rsp 0000007fbffff060 error 4
> galeon-bin[30383]: segfault at 0000003700000000 rip
> 00000037f03100da rsp 0000007fbffff060 error 4
> galeon-bin[30774]: segfault at 0000003700000000 rip
> 00000037f03100da rsp 0000007fbfffee50 error 4

Yes, I've experienced the same problems. 1.3.14 is working fine.
This should definitely be reported. Conglomerate has a similar
problem so in my opinion this is due to the new gtk+ 2.4 adoption.

It must be a general problem with gtk+ 2.4 on x86_64.  


> The same fate happens to nautilus, it seems.

Possibly, I disabled nautilus on my AMD64 because it didn't seem very 
reliable.

 
> Hardware is fine, double checked. No other software
> crashes, no sig11 etc. But it remains impossible to
> use galeon - cannot compile from source, at a certain
> point pretends to use 32 bit libs.

Let's put the involved parties in a copy.

PS I'll be disabling galeon 1.3.15 in my repository.

Thanks for your feedback,
--   dag wieers,  [email protected],  http://dag.wieers.com/   --
[Any errors in spelling, tact or fact are transmission errors]