Re: Configure fixed (#909674)

Ciao Lachlan,

Il dom, 2004-03-14 alle 04:57, Lachlan Andrew ha scritto:
> Thanks a lot for fixing the configure process.
No worries. Thank you for fixing the other problems!

> The reason for the "eval"s was to expand the definitions of the paths 
> for  htdig.conf  etc. so that they don't appear as 
> "${CONFIG_DIR}/htdig.conf" etc..  What problem were they giving you?

Now I can't reproduce it again but the problem seemed to be that the
actual configure variables were touched and a 'NONE' prefix was
introduced if you did not specify them with the configure option (that
is to say the 'default' values).

If I used 'configure' with no other options, the problem was raised;
with the prefix, some of them disappeared; as I told you, I did not have
much time to play with them and fix them properly (that's why I just
commented them out).

If I can, I will try and reproduce them. However now it should not be a
problem if you want to try a bit; just use autoreconf.

Ciao ciao,
-Gabriele



-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click
_______________________________________________
ht://Dig Developer mailing list:
[email protected]
List information (subscribe/unsubscribe, etc.)
https://lists.sourceforge.net/lists/listinfo/htdig-dev