htdig3.2 (3.2.0b6) and the use of RPATH?

Hello List,

I have packaged and submitted the 'htdig' package for the inclusion in 
Sarge. This is currently the 3.1.6 release witth all the paches that 
seemed reasonable to include. It will enter Sarge as Version  '3.1.6-9'  
or later (-9 being the Debian Revision), or perhaps with a higher debian 
revision, depends a bit if I find a few more bugs I can easily fix.

At the moment I am in the process of perparing the 3.2.0b6 package (that 
should enter Sarge as package 'htdig3.2'). According to a debian package 
control tool (lintian), I still have the following problems:

- HTFileType, htdb_dump and htdb_load, htdb_stat lack a manpage

I haven't found any infos on those programs so far, so how can I write a 
manual page about them?

- More or less all compiled binaries define an rpath (which imay pose a 
problem). Getting rid of the rpath means modifying the build process 
(the generation of libtool..). Is it possible to do that for all  
'linux/unix-like' installations, or is there any installation out there 
that relies on that rpath?

I think in other linux diustributions ir will be as much of a problem, 
even if they may have a leaner policy towards it

Yours

Robert




-------------------------------------------------------
This SF.Net email is sponsored by OSTG. Have you noticed the changes on
Linux.com, ITManagersJournal and NewsForge in the past few weeks? Now,
one more big change to announce. We are now OSTG- Open Source Technology
Group. Come see the changes on the new OSTG site. www.ostg.com
_______________________________________________
ht://Dig Developer mailing list:
[email protected]
List information (subscribe/unsubscribe, etc.)
https://lists.sourceforge.net/lists/listinfo/htdig-dev