Re: [interchange] Correct logic of DisplayErrors

Hmm. Not what I see -- I see three && or "and" changing to an or function.
I can tell you that the intent was AND.


On Mon, Sep 11, 2017 at 4:40 PM, David Christensen <[email protected]>
wrote:

>
> > On Sep 11, 2017, at 9:02 AM, M Heins <[email protected]> wrote:
> >
> > The way you can do that without changing code is to just enable it in
> > the distribution interchange.cfg. That would be my preference.
>
> Well either way, the existing code contained contradictory logic (both &&
> and || existed in the codebase), so that’s what I’m attempting to fix.
>
> So it sounds like your preference is to change it to && but change the
> default to 1, yes?
>
> Best,
>
> Davod
> --
> David Christensen
> End Point Corporation
> [email protected]
> 785-727-1171
>
>
>
>
> _______________________________________________
> interchange-users mailing list
> [email protected]
> http://www.icdevgroup.org/mailman/listinfo/interchange-users
>
>


-- 
Just because something is obviously happening doesn't mean something
obvious is happening. --Larry Wall

_______________________________________________
interchange-users mailing list
[email protected]
http://www.icdevgroup.org/mailman/listinfo/interchange-users