Re: old ic catalog (5.6.3) on new ic (5.6.10)

Il 11/10/2017 19:49, Mike Heins ha scritto:
> You'd need to give some more info. The most common cause of this type of
> thing is changing systems and having a big-endian / little-endian
> problem or 32/64 bit problem, or a problems with permissions (including
> trying to use an NFS file system).
>
>
> On Wed, Oct 11, 2017 at 7:34 PM, marco <[email protected]
> <mailto:[email protected]>> wrote:
>
>     Looked for suggestions for old mailing list archives on
>     icdevgroup.org <http://icdevgroup.org> but not found.
>
>     My old catalog elcat on new interchange 5.6.10 on startup give these
>     errors
>
>     === errors ============================================================
>     Configuring catalog elcat...LocaleDatabase locale: GDBM could not
>     tie to '/home/interch/elcat/products/locale.gdbm': Invalid argument
>     at /usr/local/interchange/lib/Vend/Table/GDBM.pm line 111, <CONFIG>
>     line 127.
>
>     RouteDatabase route: GDBM could not tie to
>     '/home/interch/elcat/products/route.gdbm': Invalid argument at
>     /usr/local/interchange/lib/Vend/Table/GDBM.pm line 111, <CONFIG>
>     line 219.
>
>     elcat config error: Unknown directive 'staticdir'
>     In line 230 of the configuration file 'catalog.cfg':
>     StaticDir     __SAMPLEHTML__/pages
>     ===
>
>     Suggestions ?
>
>     Thanks :-)

Exclude permission or big endian/little endian problems seems 32/64 bit 
problem on binary files. Text files are good.
Original files comes
  from debian 6 32 bit tgz files
  to debian 9 64 bit
I am not sure about the way I use to tgz the archive (maybe tar) but if 
i write tgz archive in ssh consolle on debian6 32, transfer it with 
samba and and read it in ssh consolle 64 bit can I have this problem ?

One way to avoid that problem ?

-- 
"Fino alla bara sinpara"
"Up to demise we rize"