Re: Sponsor development of the key motion.

 This is not needed I would think. The old elinks correctly remembers its position in every page. The old behaviour can be regained without patching to forcibly take it to the top of the page. This is worse than the cursor staying in the same geometric position.

 My question, how could a change of motion have affected the cursor being positioned so hard. Or is there some configuration that changed in elinks?

 Thanks a lot.



On Sun, Aug 12, 2007 at 08:03:04PM +0200, Witold Filipczyk wrote:
> diff --git a/src/viewer/text/draw.c b/src/viewer/text/draw.c
> index 6093315..8719156 100644
> --- a/src/viewer/text/draw.c
> +++ b/src/viewer/text/draw.c
> @@ -220,7 +220,8 @@ draw_doc(struct session *ses, struct document_view *doc_view, int active)
>  		/* When redrawing the document after things like link menu we
>  		 * have to reset the cursor routing state. */
>  		if (ses->navigate_mode == NAVIGATE_CURSOR_ROUTING) {
> -			set_cursor(term, ses->tab->x, ses->tab->y, 0);
> +			if (doc_view->last_x == -1) move_document_start(ses, doc_view);
> +			else set_cursor(term, ses->tab->x, ses->tab->y, 0);
>  		} else {
>  			set_cursor(term, box->x + box->width - 1, box->y + box->height - 1, 1);
>  			set_window_ptr(ses->tab, box->x, box->y);
> 
> 
> 
> With that patch the cursor is placed at the top of the new document,
> but when one go back the cursor position is unchanged. It's not so easy.
> _______________________________________________
> elinks-dev mailing list
> [email protected]
> http://linuxfromscratch.org/mailman/listinfo/elinks-dev