Re: documentation build issue with e.g. -j3

On 2021-02-28 Thomas Dickey <[email protected]> wrote:
> On Sun, Feb 28, 2021 at 01:59:02PM -0500, Thomas Dickey wrote:
[...] 
> > Actually, I've not found a way to reproduce problems with parallel make
> > using GNU make.

Hello Thomas,

Comparing 

(sid)ametzler@argenau:/tmp/LYNX/lynx-snapshots$ { autoreconf-dickey --verbose -f -i && ./configure --enable-htmlized-cfg CFLAGS=-DNO_BUILDSTAMP && make -j3 && mkdir INST && make -j3 install-full DESTDIR=/tmp/LYNX/lynx-snapshots/INST ; } 2>&1 | tee buildlog

with

(sid)ametzler@argenau:/tmp/LYNX/lynx-snapshots$ { autoreconf-dickey --verbose -f -i && ./configure --enable-htmlized-cfg CFLAGS=-DNO_BUILDSTAMP && make -j1 && m
kdir INST && make -j1 install-full DESTDIR=/tmp/LYNX/lynx-snapshots/INST ; } 2>&
1 | tee buildlog

both on a clean git checkout will show the "Support for this setting was
disabled at compile-time." issue in body.html. The error happens on
install-full.

> > However, it's fairly simple to reproduce similar problems
> > using BSD make (I could digress).  So I had that on a to-do list, anyway.
> > At the moment I'm testing a more involved change which fixes this issue
> > as reproduced in pmake (along with other fixes), and once done with testing
> > that set of changes, will make an update in my git snapshots.

> https://github.com/ThomasDickey/lynx-snapshots/commit/f100e91840bc2ef2cecf3d0975b734e53637fa55

This fixes my reproducer too. (Errors show up on
372d64a9e3f0d1fa9b53c5bc494f61263b19f0ff and are gone
f100e91840bc2ef2cecf3d0975b734e53637fa55.

Thank you.

cu Andreas

-- 
`What a good friend you are to him, Dr. Maturin. His other friends are
so grateful to you.'
`I sew his ears on from time to time, sure'

_______________________________________________
Lynx-dev mailing list
[email protected]
https://lists.nongnu.org/mailman/listinfo/lynx-dev