Re: Help with OW freeze

The quickie answer is to launch OW holding down the shift key
to get a fresh workspace and no tabs. Then try to figure out
which tab is having problems. (see below)

I don't see a default tab file. But the default *workspace* may
not be the one you are actually starting with. Depending on your
preferences, OW may start where you last were which very well may
not have been your default.

You could try moving your entire Workspaces directory out of
Application Support. Depending on how much you are using workspaces,
that could make a lot of your normal setup unavailable. But it would
put OW back to a "starter" state.

But if you start with the shift key held down, you can then go to
Workspace / Show Workspace and look at each of your workspaces and
either delete a broken one or delete the tab that is hanging.

I'm doing some housekeeping on my workspaces now. Some of them save
their states and some start at known tabs.

Beth Katz

On Aug 25, 2007, at 7:25 AM, [email protected] wrote:

> Hi
>
> I've got a problem. Whenever I start OW the tabs start to load then  
> the
> beachball starts spinning and I have to force quit. I tried moving the
> default tab file out of the Application Support folder but the same
> thing happens with the next tab set.
>
> Any ideas please?
>
> Thanks
> Pat O'Halloran
> http://www.danu.co.uk
> _______________________________________________
> OmniWeb-l mailing list
> [email protected]
> http://www.omnigroup.com/mailman/listinfo/omniweb-l