Re: [Pound Mailing List] Pound Failover

I use ucarp for vrrp (HA) and it's working like a charm, also I have to say
that it is very easy of configure and powerful.


Regards

2013/3/20 Jonathan Galentine <[email protected]>

> I just setup a pacemaker cluster recently and wrote about it, might save
> you some time if you go that route.
>
>
> http://techdenovo.blogspot.com/2013/03/clustering-with-drbd-pacemaker-centos.html
>
>
> Jonathan Galentine
>
> Chief Technology Officer
> 7900 Westpark Dr, Ste A50, McLean, VA 22102
> Office: (703) 891-0131 x304 | Fax: (703) 891-0129
> [email protected]  | www.ntiva.com
>
>
> -----Original Message-----
> From: Joe Gooch [mailto:[email protected]]
> Sent: Wednesday, March 20, 2013 9:45 AM
> To: '[email protected]'
> Subject: RE: [Pound Mailing List] Pound Failover
>
> I have two boxes, set ip_nonlocal_bind, each one runs pound all the time,
> and corosync/pacemaker moves the ip between them.  So pound is always
> running but it only receives requests when the cluster makes the server
> active.
>
> Joe
>
> > -----Original Message-----
> > From: James Bensley [mailto:[email protected]]
> > Sent: Tuesday, March 19, 2013 7:08 PM
> > To: [email protected]
> > Subject: [Pound Mailing List] Pound Failover
> >
> > Hi All,
> >
> > How are people achieving fail-over with Pound, in the event the server
> > becomes unavailable?
> >
> > I am thinking of something like keepalived to use VRRP to fail-over to
> > a second box if the first one fails (so they share the same public
> > IP),
> >
> > OR
> >
> > IPVS, again to share the same public.
> >
> > However, I haven't had a chance to lab up either scenario yet. Are
> > people using either of the scenarios, which do they prefer? Or if you
> > are doing something else, what are you doing, how is it working out
> > for you?
> >
> > I am primarily after active/passive fail-over, active/active is a
> > luxury extra.
> >
> > Many thanks,
> > James.
> >
> > --
> > To unsubscribe send an email with subject unsubscribe to
> > [email protected]
> > Please contact [email protected] for questions.
>
> --
> To unsubscribe send an email with subject unsubscribe to [email protected]
> Please contact [email protected] for questions.
>
> --
> To unsubscribe send an email with subject unsubscribe to [email protected]
> Please contact [email protected] for questions.
>



-- 
Load balancer distribution - Open Source Project
http://www.zenloadbalancer.com
Distribution list (subscribe): zenloadbalancer-support-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org