Re: pipelining setting

On 6/28/13, Robert Max Jackson <[email protected]> wrote:
>     For Privoxy version 3.0.21, after rereading sections 6.5 of config.txt
> on tolerate-pipelining repeatedly, I cannot figure out which setting, 0 or
> 1, tolerates pipelining.  (I fear the documentation here is completely
> ambiguous, at least for those not familiar with whatever linguistic
> assumptions would make it unambiguous.)
>
>     Could someone clarify?

0: privoxy does not handle pipelined requests
1: privoxy attempts to handle pipelined requests from the client (eg. firefox)

#  Effect if unset:
#
#      If Privoxy receives more than one request at once, it
#      terminates the client connection after serving the first one.

I'm so used to 1 is the same thing as "set" and 0 is "clear" or
"unset" that it's hard for me to imagine someone not knowing that --
assuming that is the problem with the documentation.

How would you change the documentation to make it clear that
0 = client pipelining is not allowed
1 = client pipelining allowed



Fabian - is this bit correct?

#  Default value:
#
#      None

sure looks like the default is 0

Lee

------------------------------------------------------------------------------
This SF.net email is sponsored by Windows:

Build for Windows Store.

http://p.sf.net/sfu/windows-dev2dev