Re: Log format

[email protected] wrote on 07/14/2020 02:00 PM:
>
> I'd recommend you read through the documentation concerning the content of
> the log messages, which includes detail on how to further configure the
> content thereof:https://www.privoxy.org/user-manual/config.html#DEBUGGING

Thanks, Ian, but is there an error in the documentation in the debug values 
table: after 8192 comes 32768. Shouldn't that be rather 16384, etc. ?

As I understand it the debug value is a 16-bit value, where the user can set 
any of the bits accordingly. Or is it a 32-bit value?

> You can add a column for the destination IP of the request, for example, if
> not the actual application.

Ok, I'll read about that.
But what about the mentioned 3rd value in the said log lines in my OP? What 
does it represent?