RE: WSO2 results and GZip trouble.

Fixed.

Jonathan Marsh - http://www.wso2.com - http://auburnmarshes.spaces.live.com
 

> -----Original Message-----
> From: Philippe Le Hegaret [mailto:[email protected]]
> Sent: Friday, January 12, 2007 8:05 AM
> To: keith chapman
> Cc: Jonathan Marsh; www-ws-desc
> Subject: Re: WSO2 results and GZip trouble.
> 
> On Fri, 2007-01-12 at 14:16 +0530, keith chapman wrote:
> > 10) in MessageTestFault, wsoap:code="#any". If wsoap:code is not set
> > we axis2 uses soap:Sender by deafult. This makes the http status code
> > 400 in the responce. But the test framework assumes its 500.
> 
> Amusingly, until 2 or 3 days ago, I wasn't checking for anything and I
> kept going back and forth about during the interop event :-)
> Looking again at the specification, we have:
> [[
> If the value of this property is "#any", no assertion is made about the
> possible value of the SOAP fault code.
> ]]
> http://dev.w3.org/cvsweb/~checkout~/2002/ws/desc/wsdl20/wsdl20-
> adjuncts.html?content-type=text/html;%20charset=utf-8#soap-fault-decl-
> relate
> 
> So, I conclude that I was wrong to make the change and must stop
> checking for the error code.
> 
> Philippe