[[email protected]: Re: sitecopy silently fails under cygwin]

Forwarding; this got sent to the "-bounces" address for some reason.

----- Forwarded message from Neil Cherry <[email protected]> -----

From: Neil Cherry <[email protected]>
To: Remi <[email protected]>, [email protected]
Subject: Re: [sitecopy] sitecopy silently fails under cygwin
Date: Wed, 04 Oct 2006 00:03:21 -0400

Remi wrote:
>That's exactly what I got, and I have the same configuration for the PC 
>I'm trying to run sitecopy on. Unfortunately, I've yet made it work. I 
>tried to look into the source code, seeing if at least I can figure out 
>what "53" means in this case, but no luck.
>
>Tom Robinson wrote:
>>On 2006-10-04, at 15:36, Remi wrote:
>>
>>>I posted about the same problem months ago. Nobody replied. I don't 
>>>remember what exit code it was returning... But I know it wasn't 0. I 
>>>think it was higher than 50...
>>
>>Thanks, I did search the archives but didn't find that one.
>>
>>>Out of curiosity, after hitting Enter after "sitecopy", type the 
>>>following:
>>>
>>>echo $?
>>
>>53...

Might mean:

Invalid request descriptor

It does under Linux so by extension that Cgywin uses Unix error.h
I'm guessing it's the same.

-- 
Linux Home Automation         Neil Cherry       [email protected]
http://www.linuxha.com/                         Main site
http://linuxha.blogspot.com/                    My HA Blog
http://home.comcast.net/~ncherry/               Backup site


----- End forwarded message -----
_______________________________________________
sitecopy maillist  -  [email protected]
http://dav.lyra.org/mailman/listinfo/sitecopy