Re: skunkweb starting problem ...

On Sat, Aug 06, 2005 at 12:22:17PM +0530, Amit Khemka wrote:
> Hello,
> 
>  I installled "skunkweb-3.4b5"  on a " 2.6.11-1.1369_FC4smp #1 SMP"
> with Python2.4.
> but when I try to start the skunkweb using "swmgr" it exits with the
> error messager, as reproduced below.
> 
> Strangely, the moduele "pcre" has been replaced by "sre" in the later
> releases of Python, and this release of skunkweb3.4 requires Python2
> or above ...
> 
> It would be great if you can throw some light ....

The solution is to use skunkweb-3.4.0 final, not the beta.  You are
probably using the beta because there is an rpm hanging around for it
and no one made one for 3.4.0; sorry about that, you'll have to
install it from the source tarball.  If someone makes an rpm I'll put
it up on sourceforge.

Cheers,

js

-- 
Jacob Smullyan

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.1 (GNU/Linux)

iD8DBQFC9L5QuqamFyFXXLIRAj4TAKCTzJQ8xwtSDC82jxMKP0L13k9PhQCcCSL3
F86KD9fix8QZwGmnH6SRlYw=
=wAaB
-----END PGP SIGNATURE-----