Re: 2.6.10 -- Checks Do Not Print Properly

Rich,

if the template doesn't line up it is obviously something within the
template and your latex installation which made it shift.

In SQL-Ledger variables are replaced and sent to latex for processing.
There is nothing added internally to the template so whatever
makes it shift comes from an external source.

-- 
Dieter Simader    http://www.sql-ledger.com   (780) 472-8161
DWS Systems Inc.     Accounting Software       Fax: 478-5281
============ On a clear disk you can seek forever ==========

On Wed, 24 May 2006, Rich Shepard wrote:

> On Wed, 24 May 2006, C. Duncan Hudson wrote:
>
> > We didn't notice any change in check printing when we went to 2.6.10. We
> > check PDFs directly to our check printer and they're working the same under
> > 2.6.10 as they have been since 2.5.X. Occasionally one gets printed to PS,
> > and that comes out messed up, but that' s just because we never cleaned up
> > that template.
>
> Dunc,
>
>    I don't know what happened, but I can tell you what I fixed. In the
> original check.tex, the vspace{-0.5cm} aligned the data with the pre-printed
> check fields and put the address where it would display in the window
> envelope. After wasting the seven checks, I tweaked the code using plain
> paper to test fit the results. Changing that initial spacing to vspace{1.3cm}
> moved the data to the proper place.
>
>    The result is that the template works properly once again, but I'd still
> like to learn why the adjustment was necessary. As I wrote in the original
> message, the template was created 2004-10-01 and worked fine until
> yesterday's run.
>
>    Cue the theme from The Twilight Zone.
>
> Rich
>
>



_______________________________________________
sql-ledger-users mailing list
sql-ledger-users-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org
https://lists.sourceforge.net/lists/listinfo/sql-ledger-users