Re: viewml binary

Mildred,

By default, the ViewML binary will be dynamically linked when built. This 
means that you will have external library dependencies when you are done. For 
the single file, you should use the --enable-static switch when configuring, 
which should allow you to get one single executable file with no outside 
dependencies. This assumes, of course, that you have static versions of the 
libraries available (which you should.)

Jason Kingan
Century Software

On Monday 10 February 2003 02:16 am, you wrote:
> Hi!  After compiling the the dependenciew and the viewml library, will I
> get only one executable ?  If not, is there a way I can get only one file?
> Thanks
>
> Mildred
>
> -------------------------------------------------------
>
>
> #############################################################
> This message is sent to you because you are subscribed to
>   the mailing list <[email protected]>.
> To unsubscribe, E-mail to: <[email protected]>
> To switch to the DIGEST mode, E-mail to <[email protected]>
> To switch to the INDEX mode, E-mail to <[email protected]>
> Send administrative queries to  <[email protected]>

#############################################################
This message is sent to you because you are subscribed to
  the mailing list <[email protected]>.
To unsubscribe, E-mail to: <[email protected]>
To switch to the DIGEST mode, E-mail to <[email protected]>
To switch to the INDEX mode, E-mail to <[email protected]>
Send administrative queries to  <[email protected]>