Re: [webmin-l] Search for processes > Using port/address
Paul Hancock <[email protected]>
| Newsgroups | gmane.comp.web.webmin.general |
|---|---|
| Message-ID | <ME1PR01MB0947E56F8CFB389E210C3215C8DC0@ME1PR01MB0947.ausprd01.prod.outlook.com> |
Ok, lsof installed but fuser wasn't found by YUM, however that's fine as lsof was all that was needed and port searching now works. Thanks. ________________________________ From: Jamie Cameron <[email protected]> Sent: 13 October 2016 15:23 To: Webmin users list Subject: Re: [webmin-l] Search for processes > Using port/address You need to install the lsof and fuser commands. On 12/Oct/2016 20:44 Paul Hancock <[email protected]> wrote .. What's the required package/s and/or config options to enable the aforementioned port and address search options? On a CentOS7 (systemd) headless server that is. - Paul ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot - Forwarded by the Webmin mailing list at [email protected] To remove yourself from this list, go to http://lists.sourceforge.net/lists/listinfo/webadmin-list